The Horse Forum

The Horse Forum (/)
-   Horse Tack and Equipment (http://www.horseforum.com/horse-tack-equipment/)
-   -   How to make a breakaway halter? (http://www.horseforum.com/horse-tack-equipment/how-make-breakaway-halter-31889/)

bedouin 07-18-2009 07:11 AM

How to make a breakaway halter?
 




I searched for a clear example how to make a breakaway halter. I found a lot of text but unfortunately without pictures or drawing.
Can anyone help me with pictures?


"Make A Breakaway Halter
A must-have safety measure.

By Sue Weaver

During turnouts, it's best to remove your horse's halter—halters can get hung up on fencing, trees, et cetera, leading to potential injury. However, if your horse is hard to catch when turned out, you may need to leave a breakaway halter on him. Commercial models incorporating leather crownpieces, hook and loop fasteners, and thin leather "fuses" are readily available, but you can also make breakaway inserts for halters yourself.

Remove the crownpiece buckle from a junk halter the same width as the one you're using to craft a breakaway for. Find a scrap of buckskin or thin, soft leather cut from a worn out purse, boot or coat. Cut a strip of leather the same width as the halter and 8 inches long. With a leather punch, punch a single hole in the center of the strip, 3 1/2 inches from one end (figure A). Double the leather strip so the hole is centered at the fold, and feed the salvaged buckle through that hole, shorter end up (figure B).
One inch below the first hole, punch two more holes about 1/4 inch apart.
Thread a thin leather thong up through both holes and tie a simple overhand knot. Trim the thong, then punch another hole 3/4 inch below that. It's finished (figure C).

To use it, buckle the crownpiece strap of a regular nylon or leather halter into the insert's buckle, then the insert's twin tongues into the regular halter's buckle.
Remove the insert before tying your horse: it'll pop in an instant if he spooks or leans back. But always reinsert it before turning your horse out. Breakaway inserts save horses' lives.
The author keeps a herd of horses on her Arkansas farm."

Thanx a lot in advance.

Joshie 07-18-2009 09:26 AM

Here's information about making a rope halter. I wouldn't leave a halter, break away or otherwise, on a horse.

Horse Halter | Make Horse Rope Halter

Vidaloco 07-18-2009 09:41 AM

No luck on photos. If you have someone who is good at following written directions, I think if you took those and did it step by step, you could git er done :-)

1dog3cats17rodents 07-18-2009 09:43 AM

You can buy breakaway straps in most tack shops and just buckle them on

bedouin 07-18-2009 10:12 AM

With some help from a dutch forum- this should be the result:
http://www.kensingtonproducts.com/images/kehsb.jpg


All times are GMT -4. The time now is 04:49 PM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0